Contact Us

   
North America: 1-800-769-2395   USA: 1-815-349-7004   Outside North America: 1-905-751-1362   Email: tecteg@rogers.com

Thermoelectric Parts Heat Sinks/Heat Pipes

Part # Ht-6-4-Assembly

Part # Ht-6-4-Assembly - Standard in stock

Part # Ht-6-4-Assembly Standard in stock

  • consists of 1 size: 127mm (5″)x 129.6mm (5.1″)x 6.05cm (2.4″) High 32 fin extruded heat sink
  • 1 Extender block 40 mm x 40 mm face with 12 mm wings for fasteners with – 2 holes
  • 22 mm apart and are tapped for 8-32 screws.( other size hole can be ordered)
  • 1 closed cell neoprene gasket 3/8″ thick.
  • 1 TEC1-12706 Peltier module, 15 V max , 6 amps ,51.4 watts
  • We also supply TEC1-12703, TEC1-12704 , TEC1-12706, TEC1-12708 and TEC1-127085 as substitute modules if required

Click to view PDF on Heat Sink

Heat sink assemblies complete with 6 amp, 15 Vmax thermo electric chips for cooling.

Our heat sink is idle for cooling or Thermoelectric Power Generation applications!

Heat sink size:

  • W x L x H
  • 5″ x 5.125″ x 2.5″ extruded serrated fins
  • 32 fins
Heat sink , thermo electric chip, cooling assembly, aluminum heat sink, 6 amp thermo electric, Peltier cooler, thermoelectrics , peltier chip , bonded heat sink , thermoeletric assemblies, extender blocks, solid state cooling , thermoelectric cooling, Toronto Ontario Canada, GTA, Newmarket, Aurora Ontario, Canada, water cooler replacment parts

This is one of the most concentrated heat sink designs you can buy! Fin height is almost 2″ alone (59mm) and is an extruded heat sink! All of our finsare serrated which adds additional surface area, with a thick base for heat spreading which, in turn, increases cooling efficiency for both cooling of peltier modules or cooling the cold side in thermoelectric power generation applications.

heat pipes

Adjacent are 2 heat pipes we have designed to fit up to a 40mm module. The top heat pipe will accommodate a single module while the one below will hold two 40 mm modules. These heat pipes work as good or better than most extruded or bonded heatsinks.

Other benefits include less cost and require less air flow , which in turn makes the system design more quite.

They use evaporative cooling and use environmentally friendly water as the working fluid.

Call or e-mail for your specific requirement!

1-800-769-2395

Heat sink , thermo electric chip, TEG, Thermoelectric generators, solidstate generator, power generator, low  temperature TEG generator, Waste heat power generator, remote power generator, BiTe couples, TEG components, thermoelectric generator parts, TEG Parts, TEG modules, Prototype TEG power Generator, Hot water power generator, Hot water TEG power Generator, cooling assembly, aluminum heat sink, 6 amp thermo electric, Peltier cooler, thermoelectrics , peltier chip , bonded heat sink , thermoeletric assemblies, extender blocks, solid state cooling , thermoelectric cooling, Toronto Ontario Canada, GTA, Newmarket, Aurora Ontario, Canada, water cooler replacement parts

Click on image to go to TEC peltier Module Specification’s
Cooling Chips

We carry numerous Peltier chips ( Thermoelectric Chips ) all at very competitive prices. We have been dealing with chips for 15 years . If you prefer sealed or unsealed, we can supply them.

Cascade or singles peltier chips. Just let us know! Water Cooler replacement Tec’s . Thermoelectric peltier modules are the most important part of the water cooler.

High efficiency heat pipe coils with water as the working fluid in a vacuum. ( NO CFC’S)

Heat sink , thermo electric chip, cooling assembly, aluminum heat sink, 6 amp thermo electric, Peltier cooler, thermoelectrics , peltier chip , bonded heat sink , thermoeletric assemblies, extender blocks, solid state cooling , thermoelectric cooling, wood furniture wine cabinets, wood furniture wine cabinet, exotic wood wine cabinet, exotic wood wine cabinets, custom wine cabinets, made to order wine cabinet, wine refrigerator, wine cabinet fridge, wine cellars, wood wine racks, high end wine racks, oak wine cabinet solid oak wine cabinet, solid rosewood wine cabinet, mahogany wine  cabinet, solid mahogany wine cabinet, components wine cabinet, build your own wine cabinet, cooling componants wine cabinet, glass front wine cabinet, fingerprint access wine cabinet, wine bottle cabinet, redwood wine cabinet lattice,Toronto thermoelectrics , thermoelectric Ontario, Canada, Ontario canada thermoelectrics, Wine cabinets ontario canada, refrigerated wine cabinets Toronto Ontario Canada, wood wine cabinet Toronto, Ontario, Canada , thermoelectric generators Toronto Ontario Canada ,Toronto Ontario Canada, GTA, Newmarket, Aurora Ontario, Canada, water cooler replacment parts

Evaporator Coils

This heatpipe is not only environmentally friendly, but requires NO compressor. It uses evaporative cooling and convection to cool, is extremely efficient and requires very little forced convection (fan speed) to cool. You can cool a custom cabinet for wine, which holds 100 bottles, using two evaporators and produce little or no noise.

 

W x L x H 3″ x 17″ x 12″ evaporator part # EV 001 (single 6 amp)
W x L x H 3″ x 17″ x 12″ evaporator part # EV 002 (Two – 6 amp)

 

Can be used with above heat pipe coils to increase cooling capacity. Cross flow fans are ideal when space is at a premium and noise level is crucial.

espresso, table top milk cooler, counter top milk cooler, espresso machines, super automatic machine , automatic espresso machine , commercial espresso machine, latte , cappuccino, milk cooler, MilkMate 2000, MilkMate 2000 L, Merchandiser 4Q, MilkMate 2G, wine components ,wine cabinet, wine component, wine cabinets, wine controls, wine rack, wine storage, magnetic door gasket, PVC door gaskets, counter top display refrigerator,glass front refrigerator, commercial gaskets , transformer, fans , cross flow fans , thermo electric , chips, peltier chips , Thermal Electronics  Corp., compression gaskets , compresson gasket, manufacture, design , food service coolers, medical coolers, solid-state coolers, POS, POP refrigerator, point of sale refrigerator,point of sale , cheese, salad dressing, individual portion packs, display case, NSF -7, UL approved, manufacture, design, produce,frother, milk foaming,coffee, storage refrigerator, storage refrigerators, drug storage refrigerator, drug refrigerator, drug display refrigerator, kiosks, coffee kiosks, portable carts, coffee carts, vending carts , 12 VDC , 24 VDC , compact refrigerator, cup warmer, espresso chiller, chiller, milk chiller, espresso milk chiller, frigo,TEG, mocha. power generator, thermoelectric generator, green power, reclaimed power, waste heat power generation,compact refrigerator, refrigerator magnet, counter depth refrigerator, mini refrigerator, small refrigerator, wine refrigerator, MilkMate 2005, Toronto Ontario Canada, GTA, Newmarket, Aurora Ontario, Canada, water cooler replacement parts

Three sizes of cross flow fans

L x W x D 6″ x 1.5″ x 1.5″ 12 VDC .17 amps
L x W x D 12″ x 1.5″ x 1.5″ 12 VDC .17 amps
L x W x D 14″ x 1.5″ x 1.5″ 12 VDC .34 amps

 

We inventory 3 sizes of DC fans . Call for sizes and qty. pricing.

Heat sink , thermo electric chip, TEG, Thermoelectric generators, solidstate generator, power generator, low  temperature TEG generator, Waste heat power generator, remote power generator, BiTe couples, TEG components, thermoelectric generator parts, TEG Parts, TEG modules, Prototype TEG power Generator, Hot water power generator, Hot water TEG power Generator, cooling assembly, aluminum heat sink, 6 amp thermo electric, Peltier cooler, thermoelectrics , peltier chip , bonded heat sink , thermoeletric assemblies, extender blocks, solid state cooling , thermoelectric cooling, Toronto Ontario Canada, GTA, Newmarket, Aurora Ontario, Canada, water cooler replacment parts

Muffin fans

12 VDC 120 mm x 120 mm x 19 mm .19 Slow, .43 amps Medium speed
12 VDC 80 mm x 80 mm x 19 mm .34 amps
24 VDC 50 mm x 50 mm x 19 mm .09 amps

Next Page